Applied Innovative Solutions, LLC
4255 Cove Mountain Road
Roaring Spring, Pa. 16673
email us at gwwineland@gmail.com
Our Products
Applied Innovative Solutions, LLC
4255 Cove Mountain Road
Roaring Spring, Pa. 16673
email us at gwwineland@gmail.com
Applied Innovative Solutions, LLC
4255 Cove Mountain Road
Roaring Spring, Pa. 16673
email us at gwwineland@gmail.com
Applied Innovative Solutions, LLC
4255 Cove Mountain Road
Roaring Spring, Pa. 16673
email us at gwwineland@gmail.com
To give our customers the best holding power for the speed switch attached to shafts, we have changed to include 4 magnets in all units. The former SM1part number will be SM4. Also, the former SM2 will be changed to SM2-4. The additional 160 lb pull will give a total 320 lb of holding strength and will eliminate any slipping with higher conveyor speeds and also ensure that the speed switch will not be easily knocked off from accidental rock spillage hitting it. The SM4 price remains at $380 and the SM2-4 remains at $420. We also have added the SM4SS to our line. The SM4SS is a stop switch version whereas the signal remains a constant high output when conveyor is operating but if conveyor stops, the output will dropout after 4 seconds.
We have had extreme success in areas where other brands of shaft mounted speed have failed. We strive to make our products that give piece of mind to plant automation operation.
The SM1 simply snaps on the conveyor shaft ready to ready to go. No adjustment needed. Using the sensor patent number US s10,312,907 that increases sensor distance, the SM1 sensor is located below the shaft attachment. The sensor bracket is secured to the magnetic mounting hub with a stainless steel shoulder bolt. The sensor bracket is made using Acetalal material which is water, dust and dirt resistant and extremely low friction. If sensor needs replaced, simply remove 2 allen screws from sensor holder and install new holder with sensor already secured. The sensor has a bright led for status indication.
The sensor holder that mounts to the conveyor shaft is secured by 2 100lb attraction magnets. This will give 200 total holding strength which is more than enough t0 keep it centered on shaft and not fall off.
Side view of SM1. The total width is 2 inches. This is especially useful for tight clearances especially between shaft and screen guard
If conditions require more holding strength as in higher shaft speeds. or material falling on the the SM1 with 2 magnets causing it to move off shaft, an optional SM1-4 is available. The SM1-4 has 4 magnets instead of 2. The 4 magnets will provide almost 400 lb of holding strengtth
The SM1 has a easily visible led light that can be easily seen when inspection is required. The light always faces toward the outside of shaft makes it easy to see.
The SM2 provides mounting the sensor away from shaft if needed. It has a heavy duty swivel mount to provide flexible installation. The sensor and swivel is mount on a base with 2 magnets to hold it in place on any steel structure on conveyor. Watch the video for more information.
SM1
Price $380.00
2. SM2 has been replaced with MS2-4
Price $420.00
3. SM4SS
Price $535.00
Add a footnote if this applies to your business
Direct orders welcomed. All major credit cards accepted.
Copyright © 2024 Applied Innovative Solutions - All Rights Reserved.
Call for store hours.